Component Locations; Specifications - Whirlpool WED94HEXW1 Technical Sheet

FOR SERVICE TECHNICIAN'S USE ONLY

COMPONENT LOCATIONS

Drum Light
Assembly
Door Switch
(Location may vary
between models.)
See Removing Front Panel
and Bulkhead, page 22, to access:
• Motor Assembly & Belt Switch
• Thermal Fuse
• Outlet Thermistor
• Moisture Sensor Strips
Figure 21 - Component locations.
Contacts
1M 2M 3M 5M 6M
Function
Start
Run
=
Contacts closed
Centrifugal Switch (Motor)

SPECIFICATIONS

Voltage:
Amps:
Frequency:
Water Pressure:
Operating Temperature Range:
Dryer Height:
Dryer Width:
Dryer Depth:
PAGE 26
Black
Blue
White WHITE
Gas Valve, Gas Dryer
DRYER SPECIFICATIONS
240 VAC (200-260) Elect. Dryer, 2-phase, "optimized"
208 VAC (176-229) Elect. Dryer, 3-phase, "less optimized"
120 VAC (100-130) Gas Dryer
(ELECT) 30 Amp Service
58 to 62 Hz (60 Hz nominal)
40 to 105°F (5 to 40°C)
See Removing Top Panel, page 22, to access:
• User Interface (UI)
• Cycle Control Unit (CCU)
• Inlet Thermistor (Gas)
NOTE: Refer to Figure 11b, page 14,
for gas dryer component locations.
Black-White
Red
White
Blue
Pluggable Drive Motor Switch
(GAS) 15 Amp Service
20-120 PSI
39 in. (99.1 cm)
27 in. (68.6 cm)
31 in. (78.7 cm)
DO NOT REMOVE OR DESTROY
See Removing Rear Panel,
page 22, to access:
• Water Nozzle
• Water Valve
• Thermal Cut-off
• Inlet Thermistor (Electric)
• High Limit Thermostat
• Heater Assembly
Lt. Blue
Green-Yellow
Red