Maintenance; Recommended Maintenance Schedule(S); Preparing For Maintenance - Toro 20199 Operation Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 5 hours
Before each use or daily
Every 25 hours
Every 50 hours
Yearly
Yearly or before storage
Important: Refer to your engine owner's manual for additional maintenance procedures.

Preparing for Maintenance

1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the spark-plug wire from the spark plug
(Figure 31).
Figure 31
1. Spark-plug wire
3. After performing the maintenance procedure(s),
connect the spark-plug wire to the spark plug.
Important: Before tipping the machine to change
the oil or replace the blade, allow the fuel tank to
run dry through normal usage. If you must tip
the machine prior to running out of fuel, use a
Maintenance Procedure
• Change the engine oil.
• Check the engine-oil level.
• Check the blade-brake-clutch operation.
• Check the air cleaner and clean or replace it, if necessary.
• Check the cutting blades.
• Clean grass clippings and dirt from under the machine.
• Charge the battery (electric-start model only).
• Change the engine oil.
• Service the blade-drive system.
• Service the air filter; replace it more frequently in dusty operating conditions.
• Change the engine oil.
• Service the cutting blades.
• Refer to your engine operator's manual for any additional yearly maintenance
procedures.
• Charge the battery (electric-start model only).
• Empty the fuel tank before repairs as directed and before yearly storage.
G017520
1
hand fuel pump to remove the fuel. Always tip the
machine onto its side, with the dipstick down.
WARNING
Tipping the machine may cause the fuel to leak.
Gasoline is flammable and explosive and can cause
personal injury.
Run the engine dry or remove the gasoline with a
hand pump; never siphon.
16