Clarion CX305AU Owner's Manual & Installation Instructions page 15

Mounting Screw Holes (Side View of the Main Unit)
NISSAN
NISSAN
6-Spacer (thickness: 1 mm)
Mounting bracket
(1 pair for the left and right sides)
TOYOTA
Center Panel *1
*2
Screws marked are icluded to the vehicle.
TOYOTA
6-Flat head screw (M5 × 6)
(attached to the main unit)
8-Hexagonal screw (M5 × 6)
Mounting bracket
(1 pair for the left and right sides)
Note:
*1 Some panel openings are too small for the unit depending on the vehicle type and model.
In such a case, trim the upper and lower sides of the panel frame by about 0.5 to 1.5 mm so
the unit can be inserted smoothly.
*2 If a hook on the installation bracket interferes with the unit, bend and flatten it with a nipper
or similar tool.
Vehicles other than NISSAN and TOYOTA
In some cases the center panel may require modification. (Trimming, filling, etc.)
Typical Mounting Brackets
In some cases the center panel may require modification. (Trimming, filling, etc.)
Example 1-3
Affix the screws to the mark.
Cautions On Wiring
• Be sure to turn the power off before wiring. Be particularly careful where you route the wires.
• Keep them well away from the engine, and exhaust pipe, etc. Heat may damage the wires.
• If the fuse should blow, check to see if the wiring is correct. If a fuse is blown, replace it with
anew one of the same specification as the original.
• To replace the fuse, remove the old fuse of the power supply cord and insert the new one.
Note:
• There are various types of fuse holder. Do not let the battery side touch other metal parts.
Fuse holder
• After the connection, fix the cord by a clamp or insulation tape for protection.
Fuse (15A FUSE)
CX305AU
15