Loose Parts - Toro 51480A Operator's Manual

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
1
Installing the Auxiliary Handle
Parts needed for this procedure:
1 Auxiliary handle
1 Latch
1 Brace
1. Position the auxiliary handle on the shaft of the trimmer with
the smooth surface facing the operator
2
1. Auxiliary handle
2. Latch
2. Slide the brace into the auxiliary handle so that the brace
rests in the groove along the shaft
Description
Auxiliary handle
Latch
Brace
Guard
Phillips screw
Edge guard
No parts required
(Figure 1).
1
3
G017277
Figure 1
3. Brace
(Figure 1).
Qty.
1
1 Install the auxiliary handle.
1
1
Install the guard.
1
1 Install the edge guard.
Adjust the trimmer height and the base
–
position.
3. Slide the latch from the left through the handle and brace,
and tighten the latch screw with a Phillips screwdriver
(Figure 1).
2
Installing the Guard
Parts needed for this procedure:
1 Guard
1 Phillips screw
Procedure
1. Slide the guard onto the trimmer base as shown in
4
Use
Figure 2.