Toro 51480A Operator's Manual page 5

1
1. Phillips screw
2. Secure the guard using the Phillips screw.
3
Installing the Edge Guard
Parts needed for this procedure:
1 Edge guard
Procedure
Insert the ends of the edge guard into the holes in the trimmer
housing as shown in Figure
2
G015656
Figure 2
2. Guard
3.
G017621
1. Edge guard
4
Adjusting the Trimmer Height
and Base Position
No Parts Required
Procedure
•
To adjust the auxiliary handle height, release the auxiliary
handle latch, slide the auxiliary handle up or down to the
desired height, then secure the auxiliary handle in place by
closing the auxiliary latch
5
1
Figure 3
(Figure 4).