Makita BTW074 Technical Information page 12

W
iring diagram
Fig. D-3
Route Lead wires (black, red) between
Rib A and the inner wall of Housing set (L).
Route lead wires (black, red) between Rib A
and Rib B so that they are not pinched
with Switch.
Route Lead wires (black, red) between Rib B
and the inner wall of Housing set (L).
If Connectors are put in Connector box A, route
Lead wires (black, red) through Connector box A
and secure them with Lead wire holder A .
Connectors in Connector Box A
Connectors in
Connector box B
Lead wire
holder B
Be careful not to route
any Lead wires on this Rib.
Place Line filter between Rib E and Rib F.
Note for Wiring:
If Line filter interferes with Housing set (R)
in assembling, check that Insulated terminal
is tilted enough to save the space for Line
filter referring to Fig. D-2.
BTW073, BTW103
(without Automatic Impact Stop System)
Wiring of LED Lead Wires (before setting Switch)
Wiring in Housing set (L) (after setting Switch)
Rib E
Line filter
Rib C
Connectors can be also routed
through Connector box B.
In this case, Lead wires
have to be secured with Lead
wire holder B.
Rib F
Switch
Route Lead wires connected to Switch
between Boss and the inner wall of
Housing set (L).
Boss
P 12/ 15
LED
Rib A
Rib B
Rib D
Lead wire holder A
LED