MC2 Audio MC1250 Operating Instructions Manual page 6

WARNING: Apparatus with CLASS I construction shall be connected to a MAINS socket outlet with a protective
earthing connection.
WARNING: To prevent injury, this apparatus must be securely attached to the rack in accordance with the installation
instructions.
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings, install in
accordance with the manufacturer's instructions.
8. Do not install near any heat sources, such as
radiators, heat registers, stoves or other apparatus
(including amplifiers) that produce heat.
9. Protect the power cord from being walked on or
pinched particularly at plugs, convenience
receptacles and the pint where they exit from the
apparatus.
10. The mains circuit breaker shall remain readily
accessible.
11. Only use attachments/accessories specified by the
manufacturer.
12. Use only with the cart, tripod, bracket or table
specified by the manufacturer, or sold with the
apparatus. When a cart is used, use caution when
moving the cart/apparatus combination to avoid
injury from a tip over.
13. Disconnect this apparatus during lightning storms
or when unused for a long period of time.
14. Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been
damaged in any way, such as if the power-supply
cord or plug is damaged, liquid has been spilled or
objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped.
15. Do not expose this equipment to dripping or
splashing and ensure that no objects filled with
liquids, such as vases, are placed on the
equipment.
16. To completely disconnect this equipment from the
AC mains, disconnect the power cord from the
mains circuit breaker.
17. Where the amplifier is mounted in a rack and
permanently connected to the mains, then the rack
should be installed with a readily accessible
connector or an ALL POLE circuit breaker with 3mm
breaking distances.
18. This unit is fitted with a 3-wire power cord. For
safety reasons, THE EARTH LEAD SHOULD NOT BE
DISCONNECTED IN ANY CIRCUMSTANCE.
19. The cooling fans suck cool air in through the front
and blow hot air out at the rear of the unit through
the ventilating grills. The front and rear of the
amplifier should have free exposure to the air (i.e.
in a rack leave the front and rear doors off), with
2cm air gap at the sides and top. IF AIR IS NOT
ALLOWED TO ESCAPE FROM THE REAR, OVER-
HEATING WILL OCCUR. Take care when mounting
other equipment in the same rack.
6