Honda DEH-M6156ZH Owner's Manual page 6

CD CHANGER
(MD PLAYER) ........... [9]
• The proper Honda CD changer (MD
Player) (sold separately) is required
to play CDs (MDs).
Playing of a CD (MD) is started by
pressing button [9], and stopped by
pressing button [15].
Advice
• When a CD is loaded, pressing
button [9] will alternate between
CD and CD changer (MD Player)
playback.
SWITCHING POWER ON ... [15]
If button [15] is pressed when the
power is off, the power supply of the
source before power was turned off is
turned on.
ADJUSTING VOLUME ............. [15]
The volume is increased by turning
dial [15] to the right, and decreased by
turning it to the left. (Display shows
"VOL 0" ~ "VOL 40".)
Advice
• When driving, a volume level
should be selected that allows
sounds outside the vehicle to be
heard.
6
ADJUSTING AUDIO ........... [10]
[15]
Press button [10] to switch to the
mode in which you want to make the
adjustment, and turn the dial to make
the adjustment. The adjustment mode
changes each time the dial is pressed,
as shown below.
Radio and other indicators
(Volume Adjustment)
BASS (Bass Adjustment)
TREB (Treble Adjustment)
FAD (Fader Adjustment)
BAL (Balance Adjustment)
Advice
• When bass, treble, balance and
fader adjustments are made, even
if maximum or minimum levels
are set, a beep will be heard at the
center position. The adjustment
mode is canceled approximately 5
seconds after an adjustment is
made.
Adjusting Bass
Select the bass adjustment mode.
Bass intensity is gradually increased
by turning dial [10] to the right, and
decreased by turning dial [10] to the
left. (Display shows "BASS –6" ~
"BASS +6".)
Adjusting Treble
Select the treble adjustment mode.
Treble intensity is gradually increased
by turning dial [10] to the right, and
decreased by turning dial [10] to the
left. (Display shows "TREB –6" ~
"TREB +6 ".)
Adjusting the Fader
Select the fader adjustment mode. The
balance is gradually changed to front
speaker sound only, by turning dial
[10] to the right, and to rear speaker
sound only, by turning it to the left.
(Display shows "FAD F+9" ~
"FAD R+9".)
Adjusting Balance
Select the balance adjustment mode.
The balance is gradually changed to
left speaker sound only, by turning
dial [10] to the left, and to right
speaker sound only, by turning it to
the right. (Display shows "BAL L+9" ~
"BAL R+9".)