Using The Nfc Cards - Outform iDisplay enterprise User Manual

Using the NFC Cards

A "user" NFC (Near Field Communication) card, identified by a g ay colored lock icon, is
programmed to unlock its assigned counter stand. A "manager" card, identified by a ed
lock icon, is used to configu e which user card can unlock which stand.
The counter stand must be turned on with the power supply cable plugged in for the
NFC feature to work.
To use an NFC User card:
Touch the card up against the top rear rounded edge of the counter stand with an LED.
The LED flash s blue for 10 seconds if the stand is paired with the card. During these 10
seconds, the Smart Connection adapter and tablet can be removed before the locking
mechanism automatically relocks.
Hold down the top curved edge of the counter stand with one hand and lift the tablet
up and out by gently applying upward pressure on the bottom of the tablet using the
other hand.
To use an NFC Manager card:
Touch the card up against the top rear rounded edge of the counter stand with an LED.
The LED flash s red for 10 seconds with those counter stands assigned to the manager
card set. To pair the NFC user card with the stand, the user card must touch up against
the same area on the stand within these 10 seconds. The card's previously configu ed
setting is then replaced to only unlock the new stand.
14
All Rights Reserved
C