①Af Area Adjustment - Minolta dynax 7 Repair Manual

① ① ① ① ① AF Area Adjustment
Adjustment
1. Set up the equipment as in Fig. 1.
2. Select "AREA ADJ." from the main menu and press SELECT Button.
3. Press and hold Shutter-release Button partway down after Naviagation Display goes out, so that lines
with two dents and a value appear in the display and remain for 3 sec.
Check that each line has two dents like the ones in Fig. 2, and reading is within the standard.
If not, adjust as follows.
4. Adjust the sub-mirror position using TORX L-Wrench as in Fig.3.
5. Repeat step-3 and -4 until the reading is within the standard.
6. Press SELECT Button while pressing and holding Shutter-release Button partway down (S1 ON) to
return to the previous menu.
Stanndard:96-104
■ ■ ■ ■ ■ Fig.1 Fig.1 Fig.1 Fig.1 Fig.1
AF Master Lens AF Master Lens AF Master Lens AF Master Lens AF Master Lens
1,955mm 1,955mm
1,955mm 1,955mm 1,955mm
Lens mount surface Lens mount surface
Lens mount surface Lens mount surface Lens mount surface
AF Chart-III for 2163 AF Chart-III for 2163
AF Chart-III for 2163 AF Chart-III for 2163 AF Chart-III for 2163
Align center of each island with the chart. Align center of each island with the chart. Align center of each island with the chart. Align center of each island with the chart. Align center of each island with the chart.
Fig.2 Fig.2 Fig.2
■ ■ ■ ■ ■ Fig.2 Fig.2
C a m e r a C a m e r a
C a m e r a C a m e r a C a m e r a
Focus mode: MF Focus mode: MF
Focus mode: MF Focus mode: MF Focus mode: MF
7 t h 7 t h 7 t h 7 t h 7 t h
8 t h 8 t h 8 t h 8 t h 8 t h
Fig.3 Fig.3 Fig.3
■ ■ ■ ■ ■ Fig.3 Fig.3
(2181) 43
6 t h 6 t h 6 t h 6 t h 6 t h
5 t h 5 t h 5 t h
5 t h 5 t h
4 t h 4 t h 4 t h 4 t h 4 t h
3 r d 3 r d 3 r d 3 r d 3 r d
TORX L-Wrench TORX L-Wrench TORX L-Wrench TORX L-Wrench TORX L-Wrench
1st 1st 1st
1st 1st
2 n d 2 n d 2 n d 2 n d 2 n d