Service Precautions; Notes On Soldering; Note On Insulators And Their Set Screws - Pioneer BDP-94HD Service Manual

1

1. SERVICE PRECAUTIONS

QQ

1.1 NOTES ON SOLDERING

3 7 63 1515 0
A
• For environmental protection, lead-free solder is used on the printed circuit boards mounted in this unit.
Be sure to use lead-free solder and a soldering iron that can meet specifications for use with lead-free solders for repairs
accompanied by reworking of soldering.
• Compared with conventional eutectic solders, lead-free solders have higher melting points, by approximately 40 ºC.
Therefore, for lead-free soldering, the tip temperature of a soldering iron must be set to around 373 ºC in general, although
the temperature depends on the heat capacity of the PC board on which reworking is required and the weight of the tip of
the soldering iron.
Do NOT use a soldering iron whose tip temperature cannot be controlled.
Compared with eutectic solders, lead-free solders have higher bond strengths but slower wetting times and higher melting
B
temperatures (hard to melt/easy to harden).
The following lead-free solders are available as service parts:
• Parts numbers of lead-free solder:
GYP1006 1.0 in dia.
GYP1007 0.6 in dia.
GYP1008 0.3 in dia

1.2 NOTE ON INSULATORS AND THEIR SET SCREWS

C
TE
L 13942296513
For compliance with the safety standards, removal of the insulators and their set screws, as shown in the figure below,
is prohibited. If they are removed, this product may not meet the official standards. NEVER remove these parts from
the product.
D
E
www
F
6
1
http://www.xiaoyu163.com
2
x ao
y
. i
2
http://www.xiaoyu163.com
3
8
Q Q
3 6 7
Insulator
u163
BDP-94HD
3
4
2 9 9 4
1 3 1 5 0 5 8 2 9
m
co
.
4
2 8
9 9
9 4 2 8 9 9