Installation - Hitachi VC406000 Owner's Manual

Installation

Your TV is packaged with the stand and the cabinet separated. Before using
the TV, install the stand as described below, or if you want to mount it to a
wall, see page 6 for mounting advice; the wall mount itself is not supplied.
• Make sure the TV set is unplugged from the power supply before
installing or removing the stand.
• The TV panel may be awkward to install on your own. We recommend
you ask someone to help with installation and/or removal of the stand.
Attaching the stand
Step 1
Place a soft cushioned material
on top of a flat surface to prevent
damaging the screen panel. Then
place the TV monitor flat on top,
with the screen side facing down,
as illustrated on the right (1).
Step 2
Align the screw holes on the
stand and the bottom of the TV,
as illustrated on the right (2). Push
the stand into the bottom of the
TV until the TV is fully seated on
the stand.
NOTE: Make sure the orientation
of the trapezoid head on the stand
corresponds to the trapezoid slot
on the bottom of the TV.
Step 3
Tighten the screws (supplied) with
a screwdriver to affix the stand
to the panel, as illustrated on the
right (3).
NOTE: Do not apply excessive
force as this may damage the
screw holes.
After Sales Support
Telephone: 1300 886 649
Email: info@tempoaustralia.com.au
IMPORTANT!
5