Table of Contents
Advertisement
Before using for the first time
To ensure the correct functioning of
the appliance, let it stand for between
½ and 1 hour after transporting it to its
final location before connecting it to
the mains.
Protective foil
The external surfaces of stainless steel
appliances are covered with a
protective foil.
^ Remove the protective foil only after the
appliance has been installed in its
intended location.
Cleaning and care
^ Immediately after removing the
protective foil, apply the Original
Miele Care product for stainless steel
(availabe from Miele or at
www.miele.com.au) to stainless steel
strips and frames.
^ Also apply the Original Miele Care
product for stainless steel to the side
panels after removing the protective
foil.
Appliance doors have a special
coating that is not susceptible to
soiling. Do not apply this product to
doors.
Important! Each time the Original
Miele Care product for stainless steel
is used, it forms a protective film
against dirt and water.
^ Clean the inside of the appliance and
the accessories with lukewarm water
and then dry with a soft cloth.
Switching on and off
Operating the appliance
A light touch of the finger on the
sensors is all that is required to operate
this appliance.
Switching on
^ Touch the On/Off sensor until the
temperature display comes on.
If the temperature in the appliance is
above 0 °C, only bars will light up in the
temperature display. As soon as the
temperature is below 0 °C, the
temperature display will show the
current temperature inside the
appliance.
The "Freezing" symbol and the alarm off
sensor will flash until the freezer has
cooled down to the correct temperature
for freezing.
The appliance will start to cool, and the
lighting will come on when the door is
opened.
To enable the temperature to get
sufficiently cold inside the
appliance, allow the appliance to
run for a few hours before placing
food in it.
Do not place food in the appliance
until the temperature is at least
-18°C.
13
Advertisement
Table of Contents
