Fuel Tank Assembly - Century T600 Instruction Manual

FUEL TANK ASSEMBLY

Pay close attention when assembling the fuel tank.
The vent tube must be bent and facing upwards when
installed into the rubber stopper. There are 3 holes
on the rubber stopper but notice only 2 are through
holes. Cut the fuel line and attach the clunk to the
line. Then attach the fuel line to the short brass tube.
When cutting the fuel line, make sure you have enough
slack in the fuel line so the clunk can reach all corners
of the fuel tank. After installing the shorter brass tube
with the fuel line, install the vent tube. Make sure the
vent tube is positioned to point upwards in the fuel
tank. Once you have everything positioned, slowly turn
the M3.5x24 Phillips screw so that you barely grab
the end of the small cap (#4). Once you insert the
fuel tubing assembly into the tank, it will be very dif-
ficult to get this small cap out if you happen to drop
it within the fuel tank. Making sure you still have the
small cap (#4) attached to the fuel tubing assembly,
push the fuel tubing assembly into the tank and start
tightening the Phillips screw. This will pull the small
cap (#4) closer to the large cap (#2) and expand the
rubber stopper. Once tightened, gently tug on the as-
sembly to make sure it is properly installed. It should
not come out of the fuel tank.
No.
1
2
3
CNM3.5x24ST
4
5
6
7
8
9
T600 GASSER CONVERSION
Bend one of the longer
brass tubes into this
shape. This will be the
vent tube.
4
3
2
1
Part #
HI3138B Tapping Screw( 十字紧固螺丝)M3.5x24
HI3138B Large Cap(油箱盖)
HI3138B
Rubber Stopper( 油箱塞)
HI3138B Small Cap(油箱塞固定座)
HI3138B Long Tube-straight( 长直铜油管)
HI3138B Pickup Tube-straight(短直铜油管)
HI3138B
Plastic Tubing( 塑胶油管)
HI3138B
Fuel Tank Set( 吸油嘴)
Fuel Tank(油箱)
HI6139
Page 7
9
7
6
5
Description
8
Qty
1
1
1
1
1
1
1
1
1