Replacing Light Bulbs; Headlights; Table Of Contents - Toyota 1999 Corolla Manual

Replacing light bulbs—

The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter if scratched
or dropped. Hold a bulb only by its
plastic or metal case. Do not touch
the glass part of a bulb with bare
hands.
NOTICE
Only use a bulb of the listed type.
Bulb
Light bulbs W Type
No.
60/5

Headlights

HB2
5
Parking, front side
3157N
marker and front 27/8 C
A
turn signal lights
Rear side marker
194 3.8 C
lights
Rear turn signal
3156 27 C
lights
Stop and tail lights 3157 27/8 C
Back- up lights 921 18 C
License plate lights 194 3.8 C
High mounted
— 18 C
stoplight
—
Personal light 10
Interior light — 8 D
Trunk light 194 3.8 C
A: HB2 halogen bulbs
B: Single end bulbs
C: Wedge base bulbs
D: Double end bulbs
I n f o r ma t i o n P r o v i d e d b y :
C orolla (U)
—Headlights
A
1. Open the hood.
RIGHT- HAND HEADLIGHT:
the bolts and take out the relay
block.
Put the relay block in the appropriate
place other than on the engine.
B
NOTICE
Do not place the relay block on the
engine.
Remove
201