Install Washer Dryer Machine - Technika TWDC1400 Owner's Manual

Overview of Washing Machine
Component
Detergent Drawer
Door
Service Panel
Detergent Box
Accessories
Transport Hole Plug Inlet Pipe C
Control Panel
Power Plug
Outlet Hose
Inlet Pipe H (optional) Outlet Hose Support
)
(
optional
P.08

Install Washer Dryer Machine

Unpacking the washer dryer machine
Unpack your washer dryer machine and check if there is any damage during the transportation.
Also make sure that all the items (as shown in Page 5) in the attached bag are received.
If there is any damage to the washer dryer
missing, please contact the local dealer immediately.
Dispose the packing materials
The packing materials of this machine may be dangerous to kids. Please dispose them
properly and avoid easy touch by kids. Please dispose the related packing materials
according to the relevant local regulations. Please do no throw the packing materials
away together with the other daily living rubbishes.
Remove transport bolts
Before using this washer dryer machine, transport
bolts must be removed from the backside of
this machine. Please take the following steps to
remove the bolts:
1.Loosen all bolts with spanner and then remove them.
2.Stop the holes with transport hole plugs.
3.Keep the transport bolts properly for future use.
Select the location
Before installing the washer dryer machine, the location characterized as follows shall be
selected:
- Rigid, dry, and level surface (if not level, please make it level with reference to the
following figure "Adjust Leg")
- Avoid direct sunlight
- Sufficient ventilation
- Room temperature is above 0 C
- Keep far away from the heat resources such as coal or gas.
Make sure that the washer dryer machine will not stand on power cord.
Do not install the washing machine on the carpet floor.
Adjust Leg
1.When positioning the washer dryer machine, please
first check if the legs are closely attached to the
cabinet. If not, please turn them to their original
positions with hand or spanner and tighten the
nuts with spanner.
2.After positioning the washer dryer machine,
press four corners on top cover of washer dryer
machine in sequence. If the washing machine
is not stable when being pressed, this leg shall be
adjusted.
machine during the transportation, or any item is
P.09