Troubleshooting - Technika TWDC1400 Owner's Manual

Maintenance
Pull out the power plug to avoid electrical shock before washing.
After using the washing machine, pull out the power cord and close the door tightly to avoid
pinching the kids.
Remove foreign matters
Drain Pump Filter:
Drain pump filter can filter the yarns and small foreign matters from the washings.
Clean the filter periodically to ensure the normal operation of washing machine
First, drain the water with drain pump and then open the drain pump to clean away foreign
matters from drain pump filter.
Take care if the drained water is hot.
Cleaning the pump
Important!
According to the soil level within the cycles and the frequency of the cycles,you have to inspect and
clean the filter regularly.
The pump should be inspected if the machine does not empty and/or spin;
The machine makes an unusual noise during draining due to objects such as safety pins,coins etc.
blocking the pump.
Proceed as follows:
Open the service panel Unscrew the pump cover
1 Disconnect the appliance;
2 If necessary wait until the water has cooled down.
3 Open the service panel .Place a container close to collect any spillage.
4 When no more water comes out, unscrew the pump cover and remove it.
Always keep a rag nearby to dry up spillage of water when removing the cover.
5 Remove any objects from the pump impeller by rotating it.
6 Screw the pump cover fully in.
7 Close the service panel.
Warning!
When the appliance is in use and depending on the programme selected there can be hot water in
the pump. Never remove the pump cover during a wash cycle, always wait
finished the cycle, and is empty. When replacing the cover, ensure it is securely retightend so as to
stop leaks and young children being able to remove it.
.
Remove the pump cover Close the service panel
until the appliance has
P.24

Troubleshooting

Troubles Reason
Washing machine
cannot start up
Door cannot be Machine's safety protection
opened design is working.
NTC is damaged and heating
Heating fault
pipe is aging.
The connection between inlet
pipe or outlet hose and tap or
Water leakage
washing machine is not tight.
Drain pipe in the room is blocked.
Water is
The inlet pipe is not connected
overflowed from
firmly.
the bottom of the
Outlet hose has water leakage.
machine
Power is disconnected.
Indicator or
PC board has problems.
display does
Harness has connection
not light.
problem.
Detergent
Washing powder is dampened
residues in the
and agglomerated.
box
Washing effects The clothes are too dirty.
are not good Insufficient detergent quantity.
Abnormal noise
Great vibration
Solution
Check if the door is closed tightly.
Check if power plug is inserted well.
Check if water supply tap is opened.
Check if button "Start/Pause" is pressed.
Check if button " On/Off " is pressed.
Disconnect the power.
Can normally wash the clothes.
Only cannot wash with heating.
Shall contact the service center promptly.
Check and fasten water pipes.
Clean up outlet hose and ask a
specialized person to repair it when
necessary.
Fix the inlet pipe.
Replace the drain hose.
Check if the power is shut down and
power plug is connected correctly.
If not, please call up service line.
Clean and wipe the box.
Use liquid detergents or the detergents
special for drum.
Select a proper procedure.
Add the proper detergent quantity
according to the instructions in
detergent package.
Check if the fixing (bolts) has been removed.
If cabinet is installed on the solid and level
floor.
Check if there are any barrettes or metal
articles inside.
Check if the legs in the washing machine
are adjusted level.
P.25