Copying The Program For The Usb Controller - Pioneer DDJ-T1 Service Manual

5

8.4 COPYING THE PROGRAM FOR THE USB CONTROLLER

Copy the program for the USB controller according to the following procedure after the EEPROM (IC201) on the UCOM Assy
is replaced:
1 Turn the DDJ-T1 off then connect this unit with a PC, via USB.
2 Set the POWER switch to ON while simultaneously holding the FUNCTION and LOOP OUT buttons on the left deck
pressed.
3 Copying of the program is successfully completed if the ADVANCED LED on the left deck lights then goes dark in about 3
seconds. (The ADVANCED LED flashes if nothing is connected to the USB port of this unit or copying failed for some
reason.)
After copying is completed, turn the unit off then back on again.
5
6
DDJ-T1
6
7
7
8
A
B
C
D
E
F
51
8