Niles Extender System iWare ES1 User Manual page 5

E S 1 E x t e n d e r S y s t e m U s e r M a n u a l
U S I N G Y O U R E S 1 E X T E N D E R S Y S T E M
The iWare ES1 Extender System allows you to locate your iPod anywhere from 2
® ®
meters to 100 meters from your IntelliControl ICS system or other 30-pin enabled
®
home entertainment system. Prior to performing any work you must determine
where both the system and iPod will be located. Between those two points two
lengths of category 5 unshielded twisted pair cable must be installed. These two
cables may be any length up to 100 meters and must be terminated using the EIA/
TIA T568A standard.
The input plate is different from the output plate in that it has an extra connection in
its front side for the power supply. That plate and the power supply are to be installed
at the iPod end of the system. Once both of the CAT5 cables are connected, install the
input and output plates taking great care to match the two connections at each end.
(The two RJ45 jacks are labeled "A" and "B"; Connect the cables A-to-A, and B-to-B.)
Connect the power supply to the input plate. Connect the output plate to the 30-pin
enabled system and the input plate to the iPod. As an option you can use the iWare
SmartDock™ (sold separately) to hold the iPod and add additional functionality. Please
see the manual of that device for operation instructions.
Note: In some configurations, when using the ES1 Extender System in conjunction with
the SmartDock docking station, it may be necessary to have both the SmartDock and the
ES1 Extender System's power supplies plugged in to operate the system.