Advertisement
S
S
P E A K E R
Installation Considerations
SVL-6 Power Handling
The SVL-6 is designed for use with a receiver or amplifier hav-
ing a maximum power output of 100 watts per channel at 8
ohms. Damage caused by the use of a higher-power receiver
or amplifier will void the warranty. Consult your Niles dealer,
or receiver/amplifier manufacturer, if you are uncertain about
the power rating of your receiver or amplifier.
IMPORTANT: DO NOT USE THE SVL-6 WITH AMPS OR
RECEIVERS RATED AT MORE THAN 100 WATTS PER
CHANNEL RMS AT 8 OHMS.
Amplifier Impedance Load
As more pairs of speakers are parallel connected to a
receiver or amplifier, the overall system impedance
becomes lower. For example, if two pairs of 8-ohm
speakers are connected in parallel, the impedance will be
4 ohms; two pairs of 4-ohm speakers in parallel become 2
ohms, and so on.
Most receivers or amplifiers are not rated for use below a 4
ohm load. Most manufacturers do not recommend connect-
ing more than two pairs of speakers without using some
form of impedance correction.
/ V
E L E C T I O N
C
O L U M E
O N T R O L
S
Y S T E M
TOOLS
REQUIRED
• 1/8" Standard
Slotted Screwdriver
• Wire Stripper
IMPORTANT
DO NOT use the
SVL-6 with amps
or receivers rated
at more than 100
watts per channel
RMS at 8 ohms.
4
Hide quick links:
Advertisement
