FUNCTIONS – IN-CALL
Hold/resume
TPA60:
TPA65:
Mute
TPA60:
TPA65:
MUTE
End call
TPA60:
TPA65: Hang up receiver
Transfer call
1.
Press (TPA60) or (TPA65).
2.
Dial the party to transfer to, then press
3.
When the other party answers, press (TPA60) or
hang up the handset (TPA65).
Conference call
1.
Press
or
/ (TPA65 only).
2.
Dial the party to add to the call, then press
3.
Press
CONF
or (TPA65 only).
ABOUT THE KX-A406 REPEATER
A KX-A406 repeater can be used to extend the range of a wireless
handset to include areas where reception was previously not available.
It extends the range in all directions, allowing several floors to be
covered.
REGISTERING REPEATERS
Up to two repeaters can be registered to one KX-TGP600 base unit.
Notes:
Repeaters must be registered to the KX-TGP600 base
unit one at a time.
Do not disconnect the AC adaptor of any registered repeaters
until all repeaters have been registered.
Power down any CS you do not want to connect to the
repeater before starting the registration process.
2 | Quick Reference Guide | Polycom® VVX® 310 Business Media Phone
2 | Quick Reference Guide | Panasonic® KX-TPA60® and KX-PA65® phones and KX-A406® Wireless Repeater
.
CALL
CONF
CALL
.
Step 1 (base unit)
Set the base unit to REPEATER_MODE="Y". You can change this
setting from the handset menu, configuration file or web programming.
Step 2 (base unit)
Press and hold the LOCATOR button for three seconds. The status
LED on the base unit flashes red.
Step 3 (repeater)
1.
Place the unregistered repeater near the CS.
2.
Turn on the repeater by connecting it to the AC adaptor.
The status and RSSI/ID LEDs turn amber for two seconds.
3.
If repeater is unregistered, status LED flashes red for
two seconds. The repeater automatically enters Easy
Registration mode.
4.
When repeater detects a nearby CS, status LED turns
green and registration complete.
Step 4 (base unit)
Press the LOCATOR button. Status LED turns green
De-registration
Easy Registration cannot be completed if a repeater is already
registered to another CS. To de-register the repeater:
1.
Press and hold the PROGRAM button.
2.
While holding the PROGRAM button, turn on the repeater
by connecting the AC adapter.
3.
Continue to hold the PROGRAM button for 10 seconds
until status LED turns red.
4.
Release the PROGRAM button to reset the repeater.
The repeater then enters Easy Registration mode.
Note: Skip this step if the repeater is NOT registered to a KX-TGP600
base unit.