General Power Tool Safety 3) Personal safety a) Stay alert, watch what you are doing and Warnings use common sense when operating a power tool. Do not use a power tool while Read all safety warnings and all WARNING you are tired or under the influence of instructions.
d) Store idle power tools out of the reach of Hold the power tool only by the insulated children and do not allow persons unfamil- gripping surfaces when performing an opera- iar with the power tool or these instruc- tion where the cutting tool may contact hid- tions to operate the power tool.
This could lead to a significant underestimate of expo- 7 Rotational direction switch sure when the tool is used regularly in such a way. (GBM 10 RE/GBM 10 SRE/GBM 10-2 RE/ Note: To be accurate, an estimation of the level of GBM 13-2 RE)
10 in anticlockwise direction and set the auxil- iary handle 11 to the required position. Then tighten the wing bolt 10 again in clockwise direction. 22.11.2006, Robert Bosch GmbH, Power Tools Division Adjusting the Drilling Depth D-70745 Leinfelden-Echterdingen The required drilling depth X can be set with the depth stop 12.
Page 9
, until the locking action (click) is heard. The GBM 10 SRE (see figure F): To dismount the key drill chuck is locked automatically. type drill chuck 14, firmly hold the quick-change The locking is released again to remove the tool when adapter 19.
Operation Adjusting the Speed (GBM 10 RE/ GBM 10 SRE/GBM 10-2 RE/GBM 13-2 RE) The speed of the switched on power tool can be varia- Starting Operation bly adjusted, depending on how far the On/Off switch 6 is pressed. Observe correct mains voltage! The voltage of...
Origo Ltd. would cause. Unit 23 Magna Drive Magna Business Park Belt Clip (GBM 10/GBM 10 RE) (see figure H) City West With the belt clip 23, the machine can be hung onto a Dublin 24 belt. The user has both hands free and the machine is ✆...