Intended Use; Noise/Vibration Information; Product Features - Bosch GBM 10 Operating Instructions Manual

Intended Use

The machine is intended for drilling in wood, metal,
ceramic and plastic. Machines with electronic control
and right and left rotation are also suitable for screw-
driving and tapping.

Product Features

The numbering of the product features refers to the
illustration of the machine on the graphics page.
1 Keyless chuck*
2 Front sleeve
3 Rear sleeve
4 Lock-on button for On/Off switch
5 Thumbwheel for speed preselection
(GBM 10-2 RE/GBM 13-2 RE)
6 On/Off switch
7 Rotational direction switch
(GBM 10 RE/GBM 10 SRE/GBM 10-2 RE/
GBM 13-2 RE)
8 Gear selector (GBM 10-2 RE/GBM 13-2/
GBM 13-2 RE)
9 Wing bolt for depth stop adjustment
10 Wing bolt for adjustment of auxiliary handle
11 Auxiliary handle (GBM 13-2/GBM 13-2 RE)
12 Depth stop
13 Chuck key*
14 Key type drill chuck*
15 Screwdriver bit*
16 Drill spindle with hexagon socket
(GBM 10 RE/GBM 10-2 RE/GBM 13-2 RE)
17 Securing screw for für keyless chuck/key type drill
chuck
18 Open-end spanner**
19 Quick-change adapter (GBM 10 SRE)
20 "Drilling/screwdriving" selector switch
(GBM 10 SRE)
21 Screwing-depth stop (GBM 10 SRE)
22 Adjustment sleeve for screwing-depth stop
(GBM 10 SRE)
23 Belt clip (GBM 10/GBM 10 RE)
*The accessories illustrated or described are not
included as standard delivery.
**Commercially available (not included in the delivery
scope)
16 | English

Noise/Vibration Information

Measured values determined according to EN 60745.
Typically the A-weighted sound pressure level of the
machine is 77 dB(A). Uncertainty K=3 dB.
The noise level when working can exceed 85 dB(A).
Wear hearing protection!
Overall vibrational values (vector sum of three direc-
tions) determined according to EN 60745:
Drilling in metal:
2
a =7.5 m/s , uncertainty K=2.4 m/s
h
The vibration emission level given in
WARNING
this information sheet has been meas-
ured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with
another.
The vibration emission level will vary because of the
ways in which a power tool can be used and may
increase above the level given in this information sheet.
This could lead to a significant underestimate of expo-
sure when the tool is used regularly in such a way.
Note: To be accurate, an estimation of the level of
exposure to vibration experienced during a given period
of work should also take into account the times when
the tool is switched off and when it is running but not
actually doing the job. This may significantly reduce the
exposure level over the total working period.
Vibrational emission
2
.
1 609 929 K97 • 25.1.07
value