How To Initialize The Lcd Tv/Bd - Philips 42MD459B/F7 Service Manual

HOW TO INITIALIZE THE LCD TV/BD

The purpose of initialization is to place the set in a new out of box condition. The customer will be prompted to
select a language and program channels after the set has been initialized.
To put the program back at the factory-default, initialize the LCD TV/BD using the following procedure.
< BD Section >
1. Turn the power on.
2. To enter the service mode, press the service
button on the service remote control unit.
- To cancel the service mode, press [POWER]
button on the service remote control unit.
3. To put the LCD TV/BD into the BD mode, press
[CH RETURN] or [PREV CH] on the service
remote control unit.
4. To put the LCD TV/BD into the Flash clear mode,
press [INPUT SELECT] or [SOURCE] buttons on
the service remote control unit in that order within
five seconds.
The following screen appears.
"*******" differs depending on the models.
7. SD CARD TEST
Write Protect : OK
SD Card Format : OK
SD Capacity : ***
Model Name *******
Release Ver. *.***
When "SD Card Format : OK" appears on the
screen, press [BACK] button on the service
remote control unit.
5. If screen returns to "BD Test Mode", press [8]
button.
"*******" differs depending on the models.
TEST MODE
1: MECHA TEST
2: VFD/LED TEST
3: ERROR RATE MEASURE
4: LD TEST
5: CHANNEL TEST
6: ETC TEST
7: SD CARD TEST
8: DEFAULT SETTING
Model Name *******
Release Ver. *.***
Region A-1
Region A-1
When "Default Setting : OK" appears on the
screen, the factory default will be set.
"*******" differs depending on the models.
8: DEFAULT SETTING
Default Setting : OK
Model Name *******
Release Ver. *.***
6. To exit this mode, press panel [POWER] button to
turn the power off.
Note: The name of buttons may vary with the brand
of unit.
< LCD TV Section >
1. Turn the power on.
2. To enter the service mode, press the service
button on the service remote control unit.
- To cancel the service mode, press [POWER]
button on the service remote control unit.
3. Press [INFO] button on the service remote control
unit to initialize the LCD television.
4. "INITIALIZED" will appear in the upper right of the
screen. "INITIALIZED" color will change to green
from red when initializing is complete.
7-1
Region A-1
FL9.5INT