Install Batteries And Link Sensor To Thermostat - Honeywell C7189R Installation Manual

Install batteries and link sensor to thermostat

1
Install batteries, then enter Wireless Setup mode at the thermostat. Press and
release the
CONNECT
MCR32933
Install 2 fresh AAA alkaline batteries.
Status light will briefly flash green. If it
flashes red, batteries are not good.
69-2459EFS_B.indd 1
button to link the wireless sensor to the thermostat.
Press and release CONNECT.
After a short delay, the status light
will glow green for 15 seconds.
1
MCR32934
If the status light is red, the
sensor did not link with the
thermostat. See Note.
Verify the thermostat is in the Wireless Setup
mode and the indoor sensor is at least 2 feet
away from the EIM or thermostat.
Wireless Indoor Sensor
MCR32935
69-2459EFS—03
7/13/2011 1:30:20 PM