Gvrp Commands - NetApp CN1610 Cli Command Reference

GVRP Commands

Introduction
set gvrp
adminmode
no set gvrp
adminmode
set gvrp
interfacemode
268
This section describes the commands you use to configure and view GARP
VLAN Registration Protocol (GVRP) information. GVRP-enabled switches
exchange VLAN configuration information, which allows GVRP to provide
dynamic VLAN creation on trunk ports and automatic VLAN pruning.
Note
If GVRP is disabled, the system does not forward GVRP messages.
This command enables GVRP on the system.
Default
disabled
Format
set gvrp adminmode
Mode Privileged EXEC
This command disables GVRP.
Format
no set gvrp adminmode
Mode Privileged EXEC
This command enables GVRP on a single port (Interface Config mode), a range
of ports (Interface Range mode), or all ports (Global Config mode).
Default
disabled
Format
set gvrp interfacemode
Mode Interface Config
Interface Range
Global Config
GVRP Commands