Direct Memory - PhonicEar Relation User Manual

Speed Dial Memory
To make a call from the Speed Dial Memory
1. Lift the handset and wait for the dial tone.
2. Press the desired Speed Dial Memory (M1, M2, M3) button.
3. The desired phone number will be dialled accordingly.
Alternatively:
1. Press the Speed Dial Memory (M1, M2, M3) button.
2. Then, lift the handset or press the
To copy the numbers to the Speed Dial Memory
Numbers in the Caller ID memory (See "Operation of Caller ID") or
Redial Memory can be copied to the (M1, M2 M3) memory locations. Do as
follows:
1. When a number shows on the display, press and hold the desired
memory location (M1, M2, M3).
2. The display shows "
SAVE OK
has been stored correctly.
To review the numbers in the Speed Dial Memory
1. In on-hook mode, press one of the buttons (M1, M2, M3).
2. The display will show the stored number accordingly.
The maximum number of digits which can be entered is 20. If the
NOTE:
number exceeds 20 digits, the display will show "
digits will not be stored.
18
button.
" thereby confirming that the number
" and the extra
TOO LONG

Direct Memory

Besides the Speed Dial Memory, the R
with 10 Direct Memory banks.
To store a number in the Direct Memory
1. In on-hook mode, press the
" ".
2. Enter the desired phone number. You may enter
dialling sequence. If your phone is connected to a PABX switching
system, you may enter
insert a timed delay when necessary.
3. Press the button once again, "
4. Press a numbered button from 0 to 9 to select a memory bank
location. The display will show "
5. Press the button twice to return to standby mode.
Direct Memory cannot be erased in this unit. New blank memory entries
need to be entered in each location to overwrite the old one.
To make a call from the Direct Memory
1. In on-hook mode, press and hold the desired numbered
button from 0 to 9 until the display shows the stored number.
2. Lift the handset or press the
out automatically.
To review the number in the Direct Memory
1. In on-hook mode, press and hold the desired numbered
button 0 to 9. The display will show the stored number.
The maximum number of digits which can be entered is 20. If the
NOTE:
number exceeds 20 digits, the display will show "
digits will not be stored.
telephone is also equipped
ELATION
button until the display shows
or in the
/P (PAUSE) in the dialling sequence to
" will appear on the display.
".
SAVE OK
button. The number will dial
" and the extra
TOO LONG
19