Using Your Laser - General A3G Instruction Manual

USING YOUR LASER

Power Supply
‣ The General A3G is supplied with a rechargeable Ni-MH battery pack that is
located in the base of the unit.
‣ It is recommended that the battery pack be completely charged before use.
‣ Charging time is approximately 5 hours.
‣ Use of the unit over time and changes in temperature may cause increases
or decreases in charging and operation time.
‣ The power indicator light will flash when the battery is low. The unit should
be re-charged as soon as possible.
‣ To charge the unit insert the charger into the port on the battery pack.
Progress will be shown by the power indicator display on the charger as below:
Red (flashing) = Charger and battery are not connected.
Red (constant) = Battery is charging.
Green (constant) = Battery is charged.
8