Alpine IVA-D100 Owner's Manual page 73

Foot Brake Lead / Parking Brake Lead Connection
FOOT BRAKE
(Yellow/Black)
IVA-D100
Monitor unit
PARKING BRAKE
(Yellow/Blue)
Connection Diagram of SPST Switch (Sold Separately)
(If the ACC power supply is not available)
IVA-D100
(Monitor unit
and Power
Amplifier)
• If your vehicle has no ACC power supply, add an SPST (Single-Pole, Single-Throw) switch (sold separately) and fuse (sold separately).
• The diagram and the fuse amperage shown above are in the case when IVA-D100 is used individually.
• If the switched power (ignition) lead of the IVA-D100 is connected directly to the positive (+) post of the vehicle's battery, the IVA-D100 draws
some current (several hundred milliamperes) even when its switch is placed in the OFF position and the battery may be discharged.
To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10 cm away from the car harness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
• If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various
noise suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
Pinch Foot brake lead
Connector
(sold separately)
Parking brake lamp
Pinch
Connector
Parking brake lead
(sold separately)
IGNITION
(Red)
BATTERY
(Yellow)
Foot brake lamp
Foot brake switch
Parking brake switch
SPST SW (Optional)
Chassis
Battery
FUSE (5A)
(Optional)
FUSE (20A)
(Optional)
Battery
71
-EN