Operation - DeWalt DCF060 Instruction Manual

ENGLISH
b. Check to see if receptacle is connected
to a light switch which turns power off
when you turn out the lights;
c. Move the charger and tool to a location
where the surrounding air temperature is
approximately 40 °F – 105 °F (4.5° – 4.5
°C)
d. If charging problems persist, take the
tool and charger to your local service
center.
5. The tool should be recharged when it fails
to produce sufficient power on jobs which
were easily done previously. DO NOT
CONTINUE using product with its batteries
in a depleted condition.
6. To prolong battery life, avoid leaving on
charge for extended periods of time (over
30 days without use). Although overcharg-
ing is not a safety concern, it can signifi-
cantly reduce overall battery life.
7. The batteries will reach optimum perfor-
mance after being cycled 5 times during
normal usage. There is no need to run the
batteries down completely before recharg-
ing. Normal usage is the best method of
discharging and recharging the batteries.
Safety Warnings and Instructions:
Drilling
WARNING: Tool may stall (if
overloaded or improperly used)
causing a twist. Always expect the
stall. Grip the drill firmly to control
the twisting action and prevent
loss of control which could cause
personal injury. If a stall does
occur, release the trigger immedi-
ately and determine the reason for
the stall before restarting.
• Hold tool firmly to control its twisting
action.
8
Description (FIG. 2)
WARNING: Never modify the
power tool or any part of it.
Damage or personal injury could
result.
A. Quick release collar
B. Torque control collar
C. LED Light
D. Two speed switch
E. Forward / reverse switch
F. Release button
G. Charging port

OPERATION

WARNING: Always observe the
safety instructions and applicable
regulations.
Inserting an Accessory (Fig. 2, 3)
1. Hold the screwdriver upright as shown in
Figure 3 and pull down on the quick
release collar (A).
2. Insert a hex shank accessory into the
holder.
3. Release the quick release collar.
NOTE: If bit does not fit into spindle,
rotate the bit and reinsert it.
Removing an Accessory (Fig. 2, 3)
1. Hold the screwdriver upright as shown in
Figure 3 and pull down on the quick
release collar (A).
2. Pull accessory straight out.
Switch (Fig. 2)
To turn the tool ON in a forward direction,
press the top section of the rocker switch (E)
and the tool will run. Release pressure from
the switch and the tool will stop.
To operate in reverse, press the bottom
section of the rocker switch. Without
depressing the rocker switch the tool is
locked and will act as any conventional,
non-powered screwdriver.