Table of Contents
Advertisement
• Do not disassemble the charger;
take it to an authorized service center
when service or repair is required. There
are no customer serviceable parts inside.
• Disconnect the charger from the
outlet before attempting any cleaning.
This will reduce the risk of electric
shock. Removing the batteries will not
reduce this risk..
• Use only one charger when charging.
• The charger is designed to operate on
standard household electrical power.
Do not attempt to use it on any
other voltage. This does not apply to the
vehicular charger.
• DO NOT incinerate the tool or
batteries even if they are severely
damaged or completely worn out. The
batteries can explode in a fire.
• Do not incinerate the batteries. They
can explode in a fire. A small leakage of
liquid from the battery cells may occur
under extreme usage, charging or
temperature conditions. This does not
indicate a failure. However, if the outer seal
is broken and this leakage gets on your
skin:
a. Wash quickly with soap and water.
b. Neutralize with a mild acid such as
lemon juice or vinegar.
c. If the battery liquid gets in your eyes,
flush them with clean water for a
minimum of 10 minutes and seek
immediate medical attention.
MEDICAL NOTE: The liquid is a 25-35%
solution of potassium hydroxide.
Package Contents
The package contains:
1 Cordless Screwdriver
1 Charger
1 Kitbox
1 Instruction manual
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Charging Procedure (Fig. 1)
WARNING: The batteries in your
tool are not fully charged at the
factory. Before attempting to
charge them, thoroughly read all of
the safety instructions.
WARNING: When disconnecting
the tool from the charger, be
sure to unplug the charger from
the outlet first then disconnect the
charger cord from the tool. Do not
use the tool while it is connected to
the charger.To charge your
screwdriver, follow the steps
below.
1. Plug the output cord of the charger into
the socket (G) in the bottom half of the
screwdriver handle as shown in Figure 1.
2. Plug the charger into an appropriate
outlet.
3. Let the tool charge initially for 9 hours.
After the initial charge, under normal
usage, your tool should be fully charged in
3 to 6 hours.
Important Charging Notes
1. After normal usage, your tool should be fully
charged in 3 to 6 hours. If the batteries are
run down completely, it may take up to 6
hours to become fully charged. Your tool
was sent from the factory in an uncharged
condition. Before attempting to use it, it
must be charged for at least 9 hours.
2.DO NOT charge the batteries in an air
teperature below 40 °F(4.5 °C), or above
105 °F (40.5°C). This is important and will
prevent serious damage to the batteries.
Longest life and best performance can be
obtained if the batteries are charged when
the air temperature is 75 °F (24 °C).
3. The charger may hum and become warm
to the touch while charging. This is a
normal condition, and does not indicate a
problem.
4. If the battery pack does not charge
properly:
a. Check operation of receptacle by
plugging in a lamp or other appliance;
EN GLIS H
7
Advertisement
Table of Contents
