Maintenance; Specifications - Sharp XL-UH3H Operation Manual

Maintenance

XL-UH3H
ENGLISH
Cleaning the tape-handling parts
Dirty head, capstan or pinch roller can cause poor sound and tape
jams. Clean these parts with a cotton swab moistened with com-
mercial head/pinch roller cleaner or isopropyl alcohol.
When cleaning the head, pinch roller, etc., unplug the unit which
contains high voltages.
After long use, the deck's head and capstan may become magne-
tised, causing poor sound. Demagnetise these parts once every
30 hours of playing/recording time by using a commercial tape
head demagnetiser. Read the demagnetiser's instructions care-
fully before use.
Cleaning the cabinet
Periodically wipe the cabinet with a soft cloth and a diluted soap
solution, then with a dry cloth.
Caution:
Do not use chemicals for cleaning (petrol, paint thinner, etc.). It
may damage the cabinet finish.
Do not apply oil to the inside of the unit. It may cause
malfunctions.
E-41

Specifications

As part of our policy of continuous improvement, SHARP reserves
the right to make design and specification changes for product
improvement without prior notice. The performance specification
figures indicated are nominal values of production units. There may
be some deviations from these values in individual units.
General
Power source
A Erase head
B Recording/
Power
Playback head consumption
C Capstan
Dimensions
D Pinch roller
Weight
( * )This power consumption value is obtained when the unit is in the
power stand-by mode.
Amplifier
Output power
Output terminals
AC 230 V, 50 Hz
Power on: 30 W
Power stand-by: 0.6 W(*)
Width: 170 mm (6-11/16")
Height: 227 mm (8-15/16")
Depth: 212 mm (8-11/32")
3.3 kg (7.3 lbs.)
PMPO: 66 W
MPO: 33 W (16.5 W + 16.5 W) (DIN 45 324)
RMS: 20 W (10 W + 10 W) (DIN 45 324)
RMS: 12 W (6 W + 6 W) (DIN 45 500)
Speakers: 8 ohms
Headphones: 16 - 50 ohms
(recommended: 32 ohms)