Turning On The Power - LG LSMX211ST Owner's Manual

8
FLUSH OUT THE TUBING
Turn the main water supply on and
flush out the tubing until the water
is clear.
Shut the water off at the water valve
after about one quart of water has
been flushed through the tubing.
9
CONNECT THE TUBING TO THE REFRIGERATOR
NOTE: Before making the connection to the
refrigerator, be sure that the refrigerator power
cord is not plugged into the wall outlet.
a
. Remove the plastic flexible cap from the water valve.
b
. Place the compression nut and ferrule (sleeve) onto the
end of the tubing as shown.
c
. Insert the end of the copper tubing into the connection as
far as possible. While holding the tubing, tighten the fit-
ting.
Tubing Clamp
¼ in.
Compression
Nut
Ferrule
(sleeve)
10
11
¼ in. Tubing
12
Refrigerator

Turning On The Power

Connection
1
TURN THE WATER ON AT THE SHUTOFF VALVE
Tighten any connections that leak.
CAUTION
Check to see if leaks occur at the water line
connections.
PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the wall.
Push the refrigerator back to the wall.
START THE ICEMAKER
Set the icemaker power switch to the ON position.
The icemaker will not begin to operate until it reaches
its operating temperature of 15°F (–9°C) or below. It
will then begin operation automatically if the icemaker
power switch is in the ON (I) position.
Plug in the refrigerator.
CAUTION
Connect to a rated power outlet.
Have a certified electrician check the wall outlet and
wiring for proper grounding.
Do not damage or cut off the ground terminal of the
power plug.
NOTE: A plug type might be diff erent from the
picture.
INSTALLATION 21