Technibel CAFM75R5IA Instruction Manual page 12

How to use the wireless
remote control unit
When mounting the wireless
remote control unit on a wall
Secure the installation fitting of the wireless
remote control unit using the screws.
Installation fitting of wireless
Operating tips
12
Using the Wireless Remote Control Unit (continued)
• Point the wireless remote control unit's transmitter at the signal receiver. If
the signal is received properly, a beep is heard. (Two beeps are heard
only when operation starts up.)
• Signals can be received over a distance of approximately 8 meters. This
distance is approximate: it may be slightly more or less depending on how
much charge remains in the batteries and on other factors.
• Ensure that the signals will not be blocked by any objects positioned
between the transmitter and signal receiver.
• Avoid placing the wireless remote control unit where it will be exposed to
direct sunlight or in the direct path of the air blown out from the air
conditioner, near a heating appliance, etc.
• Do not drop, throw or wash the wireless remote control unit.
• Signal reception may not be accepted in rooms with fluorescent lights that
use the electronic instantaneous lighting system (rapid start system) or
inverter system. For further details, contact your dealer.
• Before mounting the wireless remote control unit on the wall, place the
unit at the mounting position, press the ON/OFF operation button and
for use check that the signals are received properly.
• To remove the wireless remote control unit, disengage it by pulling it
toward you.
remote control unit
• Do not operate the wireless remote control unit too far away from the
signal receiver.
Doing so may cause operational errors.
Make absolutely sure that the wireless remote control unit and signal
receiver are both in the same room.
• When operating the wireless remote control unit, point it directly at
the signal receiver.
A beep is heard when a signal is received properly.
• Avoid places where the wireless remote control unit will be obscured
by curtains, etc.
Remove it before operation.
Place
Procedure for installing the wireless remote
here.
control unit
1
Press.
2