Table of Contents
Advertisement
Setting
DEFAULT
VALUES*
LOCK CONSOLE*
* If a password has been set, these settings require you to supply a proper password in
order to access them. See the OSD Security section, below, for details.
4.5.6 Factory Default Settings
The factory default settings are as follows:
Setting
Display Duration
Display Mode
Scan Duration
4.5.7 OSD Security
In order to prevent unauthorized access to the computers, the OSD provides a
password security feature. If a password has been set, the OSD will request that
the user specify it before allowing entry. To set a password:
1. Press [F6] to bring up the Setup configuration menu.
2. Move the highlight bar to Set Password, then press [Enter].
3. Key in the new password, then press [Enter].
The password may be up to 8 characters long, and can consist of any
combination of letters and numbers (A - Z, 0 - 9).
4. Key in the new password again, in order to confirm that it is correct, then press
[Enter].
factory defaults. You are asked to confirm before the
procedure goes on. Key in Y, then press [Enter] to confirm.
While the settings are being cleared, a message appears on
the display to indicate so. After the settings have been cleared,
another message appears to indicate that the procedure
completed successfully.
To lock or unlock the Console. When the Console is locked,
only the current monitor screen displays. Attempts to input
information from the console have no effect; attempts to switch
to a different port, either from the Console or by pressing the
manual switches, have no effect either. The only way to regain
access to the computers is by Unlocking the Console. If a
password has been set, you must provide the password in
order to Lock / Unlock the Console. If no password has been
set, pressing [Enter] will Lock / Unlock the Console.
Always On
The Port Number plus the Port Name
3 Seconds
Function
Default
39
RPD-1171/1178 User Manual
Advertisement
Table of Contents
