Table of Contents
Advertisement
4.2.2 Single Station Installation
In a Single Stage installation, there are no additional KVM switch daisy chained
down from the RPD-1178. To set up a single stage installation, do the following:
1. Use connector cable sets (as described in the Hardware Requirements section),
to connect any available monitor, keyboard and mouse ports of the computer
you are installing.
2. Plug the adapter cable into the RPD-1178's power jack, then plug the power
adapter into an AC power source.
3. Turn on the power to the computers
4.2.3 Two Station & Three Installation
With the combination of KVM switch box, you can cascade up to two or three levels.
For two or three stage installation, please refer to the manuals in the KVM switch box.
AC/IN 90V~264V
Note: We strongly recommend you directly contact your dealer for KVM
switch boxes.
SYSTEM 8
POWER ON/OFF
SYSTEM 4
30
RPD-1171/1178 User Manual
SYSTEM 7
SYSTEM 6
SYSTEM 3
SYSTEM 2
The rear view of the RPD-1178
SYSTEM 5
SYSTEM 1
Advertisement
Table of Contents
