Assembly - HAMPTON BAY F10013AB Use And Care Manual

Assembly

1
Assembling the fountain body
□
Select a flat, level surface for the fountain location.
□
Place the base (A) onto the ground and ensure
that it is level.
□
Position the top fountain (B) over the base (A) and
lead the water supply tube which is located under the
top fountain through the pipe which is on the top of
the fountain body. Make sure the water outlet is facing
away from the bucket of the fountain body and insert
the top fountain (B) into the base (A) until the pieces
are secured together.
2
Attaching the pump
□
Lead the water supply tube (1) out through the hole
on the back of the fountain. Insert the water supply
tube (1) into the pump (C) outlet that is on the top of
the pump (C).
□
Place the pump (C) upright into the fountain body.
□
Add clean water into the fountain body. The
required water volume is 10 liters (2.64 gallons) or
the water level should be approximately 0.8 in./20
mm lower than the hole of the fountain body.
5
Please Contact 1-855-HD-HAMPTON for further assistance.
HAMPTONBAY.COM