Circuit Protections; Fuse; Thermal Switch - Sanyo PLC-EF10EA Service Manual

Circuit Protections

This projector is equipped with the following circuit protections to operate in safety. If the abnormality occurs inside
the projector, it will automatically turn off by operating one of the following protection circuits.

Fuse

The fuse is located inside the projector. When the Mains switch on the rear panel is turned on and the lamp indica-
tor does not illuminate, fuse may be open. Remove the AV board ass'y by following below and check the fuse.
It should be used the specified fuse as follows;
Fuse Part No.: 423 025 1201
TYPE T8.0AH 250V FUSE
LITTLE FUSE INC. TYPE 215008
How to replace the fuse
1. Remove 4 screws and pull out the AV Jack board ass'y.
2. Insert slot screwdriver into a globe of the fuse holder, then push and turn the screwdriver in the arrow direction.
To install the fuse, take reversed step in the above.
-6-