Lcd Panel Replacement - Sanyo PLC-EF10EA Service Manual

LCD Panel Replacement

1. Remove the cabinet cover following to step 1 of "Mechanical Disassemblies".
2. Remove the FPC cable on the main board.
3. Remove 4 screws(A) for B-Panel, 4 screws(B) for G-Panel and 4 screws(C)
for R-Panel and pull the each LCD panel upward.
4. Remove 3 screws to take off the LCD panel from the panel holder.
When the LCD panel is replaced, it is required to re-adjust the white balance,
focus, convergence and common center adjustments, and white uniformity
adjustment if required. (Refer to the Optical and electrical adjustment.)
A
C
G-panel unit
A
B
A
B
C
R
C
LCD panel holder
LCD panel
B
When disconnecting the FPC
cable, pull out the cable lock from
the connector and then disconnect
G
the FPC cable.
B
R, B-panel unit
-21-
Connector
Cable
lock
FPC cable
LCD panel holder
LCD panel