Troubleshooting - Nikon CoolPix S202 User Manual

Nikon digital camera user's manual
Hide thumbs Also See for CoolPix S202:
Table of Contents

Advertisement

Troubleshooting

If the camera fails to function as expected, check the list of common problems
below before consulting your retailer or Nikon-authorized service representative.
Refer to the page numbers in the right-most column for more information.
Display, Settings and Power Supply
Problem
Monitor is blank.
Monitor is hard to read.
Camera turns off without
warning.
Date and time of
recording are not correct.
No indicators displayed
in monitor.
Date imprint not
available.
Date not appearing on
pictures even when
Date imprint is enabled.
Camera settings reset.
Monitor turns off, and
the power-on lamp and
flash lamp blink rapidly.
Cause/Solution
• Camera is off.
• Battery is exhausted.
• Standby mode for saving power: press the shutter-
release button halfway.
• When flash lamp blinks red, wait until flash has charged.
• Camera and computer are connected via USB cable.
• Camera and TV are connected via AV cable.
• Time lapse or interval timer photography in progress.
• Adjust monitor brightness.
• Monitor is dirty. Clean monitor.
• Monitor has dimmed to save power. Monitor
brightens when controls are used.
• Battery is low.
• Camera has turned off automatically to save power.
• Battery is cold.
• Pictures recorded before clock was set, and "Date not
set" indicator blinks during shooting, will have time
stamp of "00/00/0000 00:00"; movies will be dated
"01/01/2008 00:00."
• Check camera clock regularly against more accurate
timepieces and reset as required.
Hide info is selected for Photo info.
Select Show info.
Camera clock has not been set.
Date does not appear on movies, on pictures taken
using d, l, p, when Continuous is set to
Continuous or BSS, or when Electronic VR is set to
Auto.
Backup battery is exhausted; all settings were restored
to their default values.
Battery temperature is high. Turn off camera, and allow
battery to cool down before resuming use. After the
lamps blink for three minutes, the camera will turn off
automatically, but you can also press the power switch
to turn it off manually.
A
20
20
21, 25
29
62
60
57, 80
97
112
15
20
102
111
16
94
97
16, 94
35, 38,
40, 54,
79,
100
95
15
117

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents