CONTENTS Installation ........... 3 DIN Front-Mount (Method A) ....3 Installing the unit ....... 3 Removing the unit ......3 DIN Rear-Mount (Method B) ....3 Using the detachable control panel .. 4 Wiring Connection ......5 Operation ..........6 Radio operation ........
(b) Holder (b) Holder INSTALLATION Notes: Choose the mounting location where the unit mounting location where the unit After inserting the holder into the dashboard, After inserting the holder into the dashboard, will not interfere with the normal driving will not interfere with the normal driving select the appropriate tab according to the select the appropriate tab according to the function of the driver.
USING THE DETACHABLE CONTROL PANEL To Detach the Control panel 1. Press the release button ( ) on the front Precautions when handling panel and pull off the control panel. Do not drop the control panel. Do not put pressure on the display or control buttons when detaching or re-installing the control panel.
Use the volume knob to set Beep sound ON or OFF. OPERATION LOCATION OF KEYS Tune/seek/track up button Release button /MUTE button 4. Volume knob (when rotated) SEL button (when pressed) 5. EQ/TA button 6. DISP /Navi-SCH button 7. PTY/AF button 8.
scan preset station. LOUDNESS Press BAND/LOUD/ENT button for several STATION STORING seconds to reinforce the bass output and “LOUD” Press any one of the preset buttons (1 to 6) to will appear on the display. Press it for several select a station, which had been stored in the seconds again to release this function.
remove the USB driver from the USB SELECTING DIRECTORY UP/DOWN Press DIR- button or DIR+ button to select interface. directory downward or upward. If the MP3 files does not contain any directory, there is no function of pressing DIR- button or DIR+ button. OPERATION PAUSING PLAYING Press PAU button to pause the playing.
REMOTE CONTROL 1. MUTE:Shortly press MUT to mute the sound, shortly press it again to resume the sound. 2. BND/LOU/ENT: Band Select Button (When pressed shortly) Loudness Button (When pressed long) (Enter Button For MP3/WMA file Operation) 3. 1 PAU: Pause Button 4.
SPECIFICATION GENERAL Power Supply Requirements : DC 12 Volts, Negative Ground Tone Controls Bass (at 100 Hz) : ±10 dB Treble (at 10 kHz) : ±10 dB Maximum Output Power : 4X40watts Current Drain : 15Ampere (max.) USB/SD/MMC PLAYER Signal to Noise Ratio : More than 55 dB Channel Separation : More than 50 dB...
TROUBLE SHOOTING Before going through the checklist, check wiring connection. If any of the problems persist after checklist has been made, consult your nearest service dealer. Symptom Cause Solution The car ignition switch is not If the power supply is connected No power.