Table of Contents
Advertisement
To erase all the pairing registration
information
1
Press BLUETOOTH
unit.
When the system is connected with a
Bluetooth device (when the Bluetooth
device name or other information
appears in the system display), press
and hold BLUETOOTH
unit for about 2 seconds to put the
system in Bluetooth standby mode.
2
Press CLEAR
"Delete?" appears.
3
Press ENTER
"Complete!" appears and all the
pairing information is erased.
Note
In order to connect with a Bluetooth device
after performing this operation, you must enter
the passkey again.
Playing music of a Bluetooth device
You can operate a Bluetooth device by
connecting the system and a Bluetooth
device using AVRCP.
1
Select the Bluetooth function.
Press BLUETOOTH
the unit.
2
Establish a connection from the
Bluetooth device.
For details about the operations of
the Bluetooth device, refer to the
operation manual supplied with your
Bluetooth device.
Once the connection is established,
the system display changes as follows:
"Connect" Name of the Bluetooth
device
1
GB
on the
on the
.
.
on
3
Start playback.
Press (or BLUETOOTH on
the unit)
.
Depending on the Bluetooth device,
you may need to start up the AV
software of the Bluetooth device
beforehand.
4
Adjust the volume.
Press VOLUME +/ (or VOL +/ on
the unit)
.
To check the address of a connected
Bluetooth device
Press DISPLAY
while the Bluetooth
device name appears in the system
display.
The Bluetooth device address appears for
8 seconds.
To cancel the connection with a
Bluetooth device
Press and hold BLUETOOTH
on the unit for about 2 seconds until
"Disconnect" appears, or until the
information on the display (device name,
etc.) disappears.
Other operations
To
Press
Pause playback (or BLUETOOTH
on the unit)
Stop playback
Select a folder
/
Select a file
Hold down /
Find a point in
a file
.
.
.
+/
.
.
Hide quick links:
Advertisement
Table of Contents
