Geneva Cinema Manual page 7

BluEtooth
Mobile phones and computers with Bluetooth can connect to the Model Cinema and play music. The mobile phone or computer must support
Bluetooth A2DP.
initial setup ( "pairing" ) with iphone
1. Press the key on the remote control. Wait for 20 seconds until
the Model Cinema display is blinking "PAIR".
2. Select "Settings" on your iPhone
Turn on Bluetooth. New Bluetooth devices are detected
automatically. After a few seconds "Geneva Cinema ( Not Paired )"
will be displayed.
3. Select "Geneva Cinema". The phone is now connecting
( being paired ) to the Model Cinema.
4. Once "paired", you can play music on the iPhone
on the Model Cinema.
pairing guides for other devices and mobile phones
Go to www.genevalab.com and select "Support."
Bluetooth settings on iPhone
linE in
The Model Cinema has a line-in input ( 3.5mm, stereo connector ) for external audio devices.
1. Connect one end of a 3.5mm cable to the Line-In connector at the
back of Model Cinema.
2. Then connect the other end of the cable to the audio device
( headphone or Line-Out connector ).
3. Press on the remote control.
®
. Select "General / Bluetooth".
®
and listen to it
®
®
status information on the display
"srch": Searching previously paired devices.
"connEctEd": Connection successfully established.
"pair": If the Model Cinema failed to set up a successful connection
within the first 20 seconds, it will continue to do so in the pairing mode
for 2 minutes.
playing Music
Most phones connect automatically to the Model Cinema after the
initial setup ( "Pairing" ).
1. Press the key on the remote control. While the Model Cinema
connects, the display shows "CONNECTED" for a few seconds.
2. Now the music that is playing on your mobile phone will
automatically be streamed to the Model Cinema.
Selecting Bluetooth as audio output
( control center of iOS7 )
English
5