Activating/Deactivating The Handset - Gigaset C510 Manual

Manually registering the handset to the Gigaset C510/C510A base station
You can register your handset on up to four bases. You must manually register the handset on
both the handset (1) and the base (2).
1) On the handset
Menu ¤ Settings ¤ OK ¤ Registration ¤ OK ¤ Register Handset ¤ OK
¤ Enter the base system PIN (default setting: 0000) ¤ OK
The display shows Handset is registering.
2) On the base
Within 60 seconds of entering the system PIN, press and (¢ page 1) hold the registration/
paging key (min. 3 seconds).
Registration takes approx. 1 minute.
Handsets are assigned the lowest available internal number (1-4). If the internal numbers 1–4
are already assigned to other devices, the number 4 is overwritten.
Changing the display language
If you do not understand the language that has been set, press:
L4 (press slowly)
Menu ¤
a
¤
(press and hold to return to idle status)
Setting the date and time
Set the date and time so that the correct date and time can be assigned to incoming calls, and
so that the alarm clock can be used.
Menu ¤ Settings ¤ OK ¤ Date/Time ¤ OK
~
¤ Enter Date: ¤ (enter the year, month and day in 8-digit format) ¤ OK
~
¤ Enter time: ¤ (enter hours and minutes in 4-digit format) ¤ OK (display message: Saved)
a
¤
(press and hold to return to idle status)
Please note
When entering the time and date, you can move the position of an entry to the left or right
by pressing left or right on the control button.
Display in idle status
Once the phone is registered and the time set, the idle status is shown as in this example. If the
answering machine is switched on (C510A), the answering machine icon
in the header. Your answering machine is set with a pre-recorded announcement.
The strength of the reception signal between base and handset:
Ð ¨ § ¦
– Good to poor:
¥
– No reception:
Charge status of the batteries:
U
– Batteries charged to over 66 %
V
– Batteries charged to between 34 % and 66 %
e
– Batteries charged to between 11 % and 33 %
=
– Flashes: batteries charged to below 11 %
= e V
–

Activating/deactivating the handset

Press and hold the end call key
If you place a deactivated handset in the base or charging cradle, it will automatically be acti-
vated after a specific period of time (approx. 30 seconds).
Your phone is now ready for use!
If you have any questions about using your phone, please read the tips on troubleshooting
("Questions and answers", ¢ page 14) or contact our Customer Care team page 14.
6
q
¤ Select language ¤ OK (
U
Charging
a
to activate or deactivate the handset.
‰
= selected)
±
will be displayed
Ð
±
INT 1
11.12.
Redial
V
11:56
Menu