Setup Instructions; Product Specifications; Motor Pre-Filtering Assembly - Intex Krystal Clear SF15220 Owner's Manual

Hide thumbs Also See for Krystal Clear SF15220:

Owner's manual (29 pages)

Table Of Contents

Table of Contents

PRODUCT SPECIFICATIONS

The sand filter removes suspended particles but does not sanitize your pool.

Pool chemistry is a specialized area and you should consult your local pool

service specialist for details.

Power:

Wattage:

Maximum working pressure:

Effective filtering area:

Maximum Flow Rate:

Recommended filtering media:

(Not included)

Recommended filtering media quantity: No. 20 silica sand 25 Kg (55 Lbs) or glass sand

Limited Warranty:

NOTE: NOT SUITABLE FOR USE WITH KCP-LOW -SALT AUTOMATIC SALTWATER

SYSTEM (MODEL 6110/6220)

TOOLS REQUIRED:

Pump location and mounting:

• The system must be installed on a solid level and vibration-free base.

• Provide a location protected from the weather, moisture, flooding and

freezing temperature.

• Provide adequate access, space and lighting for routine maintenance.

• Pump motor requires free circulation of air for cooling. Do not install

the pump in a damp or non-ventilated location.

A team of 2 or more people is recommended for setting up this product.

Motor pre-filtering assembly setup:

Remove the sand filter and its accessories

from the packaging carefully and inspect for

any visible damage. If parts are damaged

contact your local service center listed at

the back of this owner's manual.

In a counter-clockwise motion unscrew the

leaf trap cover (14) from the pre-filter

housing. Take out the basket (16) and filter

housing nut (17) (see drawing 10).

Connect the pre-filter housing to the motor

water inlet. Note: Align the connector in the

pre-filter housing with the water inlet on the

motor (see drawing 11).

SAVE THESE INSTRUCTIONS

(162) MODEL SF15220 SAND FILTER PUMP ENGLISH 7.5" X 10.3" PANTONE 295U 08/29/2012

220-240 Volt AC

370 W

2.4 bar (35 psi)

0.1 m

6056 liters/hour (1600 gallons/hour)

No. 20 silica sand or glass sand. Particle size

range 0.45 to 0.85 mm (0.018 to 0.033 inches).

Uniformity Coefficient less than 1.75.

18 Kg (40 Lbs).

see "Limited Warranty"