Table of Contents
Advertisement
time start. Press the * key followed by the 9 key, then press the 4 key. The
buzzerwill emit a low level steady tone.
As you test each device the internal sounder will give a loud pulsing tone to
indicate the correct operation of that device. The zone number LED will light.
When the device tested clears the sounder will stop and the zone LED will go
out. The buzzer will emit a low level steady tone as before.
Report any faults to your alarm installation company.
Press the * key to finish.
The following is given so a record of your zone configurations can be made.
simply fill in where each zone is located in your premises.
THE FOLLOWING IS PROVIDED TO GIVE QUICK ACCESS TO VARIOUS
PEOPLE IF A PROBLEM OCCURS
This manual is from
http://groups.msn.com/UKSecurityPanels
Technical Manuals Online! - http://www.tech-man.com
Advertisement
Table of Contents
Need help?
Do you have a question about the Securit 700L and is the answer not in the manual?
Questions and answers
How do I change my user code
To change the user code on a C & K Systems Securit 700L:
1. Enter the current four-digit user code.
2. The buzzer will emit a steady sound, and the exit time will start.
3. Press the * key followed by the 9 key.
4. Press the key corresponding to the user code to be changed:
- Press 1 to change the Master user code.
- Press 2 to change the Second user code.
5. Follow the prompts to complete the code change process.
This answer is automatically generated
How to clean keypad on C&k securitech alarm
bought a house with securitech 700L with no code, how do change the code if i dont have the original code