Unsetting ( Used To Dis-Arm The Control Panel ); Tamper Faults During An Unset Condition; Alarms During The Set Period; Personal Attack Alarms - C & K Systems Securit 700L User Manual

http://groups.msn.com/UKSecurityPanels
rejected. You must then re-enter the "*" if needed. If option 7 5 has been
enabled by your installer you can also manually isolate the entry exit zone in
part set.

2.0 UNSETTING ( Used to dis-arm the control panel )

Enter by the specified route, the buzzer will sound, do not stop go directly to
the control panel. Enter your four digit code, the buzzer will stop and the
control panel will return to the 'DAY' mode. If the exit time has less than 10
seconds remaining the buzzer will emit a quick pulsing sound to indicate
"HURRY UP". If this happens continue on to the control panel and enter your
4 digit code as stated.

3.0 TAMPER FAULTS DURING AN UNSET CONDITION

A tamper fault during an unset condition ( ie daytime) is indicated by the
internal sounder and the tamper LED. Enter the four digit user code to stop
the sounder, the sounder will now change to a low level two tone alternating
sound to indicate that there is a "RESET REQUIRED". Press the # key to
reset the control panel.

3.1 ALARMS DURING THE SET PERIOD

Alarms during a set period ( ie night time ) will be indicated by the internal
AND external sounders going into alarm and also the strobe unit (if fitted) will
begin to flash. Enter your four digit user code to unset the system. The LED
display will indicate which zone caused the alarm. See section 3.3 to reset the
control panel.

3.2 PERSONAL ATTACK ALARMS

When a personal attack alarm is triggered it is usually triggered from a button.
You should go firsts to the control panel and enter your four digit code and
follow it with the "#" key. you should then look to see if the PA light is still
flashing. If it is then
it is denoting the PA circuit is still open. Check each PA button visually to see
if it is still triggered and if it is, reset it using the appropriate key provided with
that button.
For further information on resetting an alarm condition of any kind see the
below section.

3.3 RESETTING THE SYSTEM

To reset the control panel enter the user code the sounder will emit a low
level two tone alternating sound to indicate that there is a "RESET
REQUIRED".
Press the # key to reset the control panel. An accept tone will be given, the
LEDs for
the zones in alarm will go out, and the control panel will return to the 'DAY'
mode.
This manual is from
http://groups.msn.com/UKSecurityPanels
Technical Manuals Online! - http://www.tech-man.com