Setting; Full Set ( Used When Leaving Premises ); Part Guard ( Used When Going To Bed ); Manual Isolation ( Used To Switch Off Various Zones ) - C & K Systems Securit 700L User Manual

This manual will give you all the information you need to operate and control
the Securit 700L Control Panel. This manual will NOT tell you how to program
or configure the control panel, for that see the engineering instructions.

1.0 SETTING

1.1 FULL SET ( Used when leaving premises )

To start the exit procedure ensure all alarmed zones are clear. Now enter
your four digit user code, the buzzer will emit a steady sound and the exit time
start.
Leave the building by the approved exit route and close the final exit door.
Wait
outside the door until the buzzer has stopped to indicate that the panel has
armed.
If any zones are in fault the buzzer will pulse and the LED for that zone will be
lit. Return to the panel and press the "#" key or enter the user code to abort
the exit
procedure. Investigate the fault and correct if possible, then start the exit
procedure
again. If you are unable to correct the fault contact your alarm Installation
company.
If you do not complete the exit procedure before the exit time runs out the
internal
sounder will start. Enter your user code to stop the sounder. See section 3.3
to reset
the control.

1.2 PART GUARD ( Used when going to bed )

Start the exit procedure as for full set as above. Then press the "*" key
followed by the "0" key. The buzzer will change tone to a lower, deeper sound
and
the LED's for any zones programmed to be isolated in part guard will flash.
The
programmed part guard exit time will be selected and the exit procedure will
continue. If when performing this procedure you delay for more than 3
seconds
between the "*" and the "0" then an error tone will be heard. Restart the exit
procedure followed by "*" then "0" and continue with your exit procedure.

1.3 MANUAL ISOLATION ( Used to switch off various zones )

Start the exit procedure as for full or part set as given above. Then press the
"*" key followed by the number of a zone you require to isolate. If the zone is
accepted is will now isolate and the LED for that zone will flash and the exit
procedure will continue. If you require any further zone to be isolated then
again
press "*" followed by a zone number. Again the time between "*" and a zone
number
must not exceed 3 seconds or it will be classed as an error or mis-key and it
will be
This manual is from
Technical Manuals Online! - http://www.tech-man.com