Installation Test (Exhaust Check) - LG DLE4801W Owner's Manual

26
INSTALLATION INSTRUCTIONS

Installation test (Exhaust check)

Once you have completed the installation of the dryer, use this
test to make sure the condition of the exhaust system is adequate
for proper operation of the dryer. This test should be performed
to alert you to any serious problems in the exhaust system of your
home.
FLOW SENSE
that automatically detects blockages and restrictions in dryer
restrictions allows clothes to dry faster and reduces energy use.
NOTE
The dryer should be cool before starting this test. If the dryer was
warmed up during installation, run the AIR DRY cycle for a few
minutes to reduce the interior temperature.
time. While holding these buttons, press POWER ON/OFF
The dryer will show lnS in the number display to indicate that
it is in duct condition testing mode.
3. Press the START/PAUSE button.
blockages or restrictions to air flow in the ductwork.
TM
, an innovative sensing system
4. Check the display for results.
During the two minute test cycle, monitor the FLOW SENSE
display on the control panel. If FLOW SENSE is displayed, when
the cycle ends, the exhaust system is adequate. If the exhaust
system is severely restricted, the display will show FLOW
SENSE. Other problems may also be shown with error codes.
Refer to the next page for error code details and solutions.
Lighting : Restricted
FLOW SENSE indicates that the exhaust system is severely
restricted. Have the system checked immediately, as performance
will be poor.
At the end of the test cycle,
will end and the dryer will shut off automatically after a short
delay.
will display. The test cycle