Specifications; Using Smartdiagnosis - LG DLE4801W Owner's Manual

34

SPECIFICATIONS

Before calling for service (cont.)
Problem
CHECK FILTER light
is on during the
drying cycle
FLOW SENSE
Light is on during the restrictions.
drying cycle
lint buildup or debris.
the external dryer venting.
SPECIFICATIONS
Dryer models
Description
Electrical Requirements*
Gas Requirements*
Dimensions
Net Weight
Drying Capacity
- Normal Cycle

USING SMARTDIAGNOSIS

NOTE
- Only use this feature when instructed to do so by the call center. The transmission sounds similar to a fax machine, and so has no meaning
except to the call center.
- SMARTDIAGNOSIS™ cannot be activated if the dryer does not power up. If this happens, then troubleshooting must be done without
SMARTDIAGNOSIS™.
If you experience problems with your dryer, call 1-800-243-0000 (1-888-542-2623 in Canada). Follow the call center agent's instructions, and do
the following steps when requested:
1. Press to turn on the dryer. Do not press any other buttons.
2. When instructed to do so by the call center agent place the mouthpiece of your phone very close to the POWER button.
3. Press and hold Temp.button for three seconds, while holding the phone mouthpiece to the icon or POWER button.
4. Keep the phone in place until the tone transmission has finished. This takes about 17 seconds, and the display will count down the time.
5. Once the countdown is over and the tones have stopped, resume your conversation with the call center agent, who will then be able to assist
you using the information transmitted for analysis at the call center.
Possible Causes
DLE4801W DLG4802W
Dryer
Please refer to the rating label regarding detailed information.
NG 4-10.5 inches WC
LP: 8–13 inches WC (Gas Models only)
26.4"(W) X 29.2" (D) X 43.7" (H), 51" (D with door open)
67.1cm(W) X 74.3cm(D) X 111.0cm(H), 129.5(D with door open)
124.9 lbs (56.6 kg)
IEC 7.1 cu.ft. (22.5 lb/10.2 kg)
TM
Dryer can be used in this condition, but drying times may be longer.
will remain on for two hours after the end of the cycle. Opening the door or
pressing the POWER button will turn off the display.
SMARTDIAGNOSIS™.
Solutions
TM
system, the indicator